Polycom C16 Manual do Utilizador descarregar pdf (Página 203)

100

101

Installing SoundStructure Devices

7 - 27

Once the empty partial preset has been created, the next step is to add com-

mands to the partial preset by clicking the ‘+’ control. This will add an empty

line to the partial preset, and allow the designer to select the parameter to

adjust with this line as shown in the following figure.

Partial presets are entered one command at a time by pulling down the appro-

priate parameter and adjusting the action (set, inc, dec, tog) and selecting the

arguments for the parameter.

The column headers of the partial preset may not be sorted as this would

change the execution order of the partial preset. However the column widths

may be adjusted on the preset content table to allow showing the full parame-

ters that are being added.

Once the contents have been added to the preset, ensure the ‘Save Selected’

button is pressed to ensure the preset contents are saved with the configura-

tion file.

Navigating away from the partial preset prior to saving will remove

all the entries from the partial preset.

Reordering Entries In A Partial Preset

The order of execution of the commands in a partial preset may be adjusted by

changing the order of the lines in the partial preset. To move a line, select the

line and select the up or down arrow as shown in the following figure.

To save the partial preset after adding commands, select the ‘Save Selected’

button.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 491 492

Comentários a estes Manuais

Sem comentários

Polycom C16 Manual do Utilizador Página 203

Comentários a estes Manuais