Polycom DOC2237A Manual do Utilizador descarregar pdf (Página 61)

MGC Hardware and Installation Manual

2-41

Clocking

To be able to work with the network connected to the MCU you need to

synchronize the system clock with the network clock. This is done in two

steps:

• Selecting the network type according to which the system clock will

synchronize. Only one system type may be selected for clocking. The

clock source is then defined in the “system cfg”.

• Selecting the spans of the selected network that will act as Master and

Backup clocks. The Master and the Backup clock must be set on spans of

the same network type.

For more details regarding the clocking setup, see the MGC Administrator’s

Guide, “Clocking” in Chapter 5.

You have completed the hardware installation. The next step in the

installation procedure is to install the MGC Manager software. For more

information, refer to the MGC Administrator’s Guide, Chapter 2.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 169 170

Sem comentários

Polycom DOC2237A Manual do Utilizador Página 61