Polycom DOC2237A Manual do Utilizador Página 23

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 22
MGC Hardware and Installation Manual
2-3
3. Release the clasp locks at the bottom, and lift the MGC-100 top cover.
Figure 2-2: Unpacking the MGC-100
4. Lift the MGC-100 unit and remove the packaging material.
5. Lower the MGC-100 unit, placing it on the surface.
If the MGC-100 is a standalone unit, place it on a flat surface. If you are
rack mounting the MGC-100, allow a minimum clearance of 3” above
the unit. If you are rack mounting the NEBS MGC-100, the 3” above the
unit is not needed. Refer to the NEBS Standards for clearance
compliance.
Foam Block
Foam Block
Wood Packing Case
Vista de página 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 169 170

Comentários a estes Manuais

Sem comentários