Polycom 6000 Manual do Utilizador descarregar pdf (Página 105)

Statistics and Diagnostics

11 - 11

System Log Settings in the Polycom QDX 6000 Web Interface

To configure system log settings via the Polycom QDX 6000 web interface:

1. On a computer, open a web browser.

2. In the browser address line, enter the system’s IP address, for example,

http://10.11.12.13

, to go to the Polycom QDX 6000 web interface.

3. If prompted, enter the administrator account ( “admin” is default), and

enter the admin password.

4. Click Diagnostics > System Log > System Log Settings.

5. Configure these settings:

Setting Description

Log Level Sets the minimum log level of messages stored in the

Polycom QDX 6000 system flash memory. DEBUG logs

all messages. WARNING logs the fewest number of

messages.

Polycom recommends leaving this setting at the default

value of DEBUG.

Remote Logging

Enabled

Specifies whether remote logging is enabled. Enabling

this setting causes the Polycom QDX 6000 system to

send each log message to the specified server in addition

to logging it locally.

The system immediately begins forwarding its log

messages when you click Update.

Encryption is not supported for remote logging, so

Polycom recommends remote logging only for secure,

local networks.

Remote Log Server Specifies the domain name or IP address of the syslog

server. The server must support the standard syslog

protocol (RFC 3164).

Enable H.323 Trace Logs additional H.323 connectivity information.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 125 126

Sem comentários

Polycom 6000 Manual do Utilizador Página 105