Polycom RMX DOC2548A Manual do Utilizador descarregar pdf (Página 60)

Chapter 2- Component Replacement

2-18

Replacing the Fabric Switch Module (FSM 4000)

1 Ensure that the power switch/circuit switch on the RMX 4000 is

turned OFF (O).

2 Loosen the captive screws that fasten the module to the MCU.

3 Remove the Fabric Switch Module (FSM 4000). Use the metal ejector

levers to pull the Fabric Switch Module (FSM 4000) out of its slot in

the backplane.

4 Carefully slide the Fabric Switch Module (FSM 4000) out through the

front panel.

5 On the card to be installed, move the ejector levers to their fully open

position.

6 Slide in the replacement Fabric Switch Module (FSM 4000).

7 Push the Fabric Switch Module (FSM 4000) firmly into the backplane,

making sure it is properly seated in its slots.

8 Ensure that the metal ejector levers are fully retracted into their

housings.

9 Tighten the captive screws on the rear panel of the RMX 4000 that

secure the Fabric Switch Module (FSM 4000).

10 Turn ON the RMX 4000.

1 2 ... 55 56 57 58 59 60

Sem comentários

Polycom RMX DOC2548A Manual do Utilizador Página 60