Polycom DOC2231A Manual do Utilizador descarregar pdf (Página 112)

MGC+50/MGC+100 Getting Started Guide

8-10

For more information about viewing card parameters, see MGC Manager

Administrator’s Guide, Chapter 4.

Clock This column is valid only for ISDN and Serial (MPI-8)

Network Interface cards.

On the Net-2/Net-4/Net-8 Network Interface Module,

the Master and the Backup clocks can be set on any

of the spans connected to the module.

This column indicates which Network card/span is

used as the Master Clock and which one is used as

the Backup clock.

Configured Clock Indicates which ISDN Network card or MPI Span

was configured as the Primary network interface (for

clocking), and which one is used as backup.

Changes take effect and are updated during the next

MCU reset or power up.

Status Indicates the card status; Normal or Faulty.

Occupied Units Indicates the units on the card that are currently

used to run conferences. For example, 1, 6 indicates

that two units, unit # 1 and unit # 6 are used to run

conferences.

Faulty Units Indicates if there are units on the card which are

faulty and the sequential number of the faulty unit.

Disabled Units Indicates the units that were disabled by the

operator.

Num Units Indicates the total number of units available for each

module.

Table 8-2: MCU's Cards Status Columns

Field Description

1 2 ... 107 108 109 110 111 112 113 114 115 116

Sem comentários

Polycom DOC2231A Manual do Utilizador Página 112