Polycom KIRK IP Manual do Utilizador descarregar pdf

Polycom

KIRK IP Interface Card - User Guide

1. Introduction

This guide helps you setting up the KIRK Wireless Server 1500 with IP Interface Card on a Cisco CallManager.

Please refer to your CallManager user manual for general information.

2. Installation

1. Power down the WMS (Wireless Mobility Server).

2. Remove the top cover by unscrewing the screws on both sides of the WMS and the screws at the rear panel.

3. Remove the blind cover plate in front of the slot

closest to the power supply (please refer to the

figure at right).

4. Insert the KIRK IP Interface Card into the slot 0

(see drawing) and mount the two screws from the

blind cover.

5. Put back the top cover.

6. Connect an RJ45 cable (not included) between the

KIRK IP Interface Card on the back of the WMS

and the LAN network.

7. Power up the WMS again.

8. Verify that the LED’s are flashing as follows:

Active

In HTTP mode and when packets are transmitted on the Ethernet the Active LED is turned on.

100

In HTTP mode and when the Ethernet speed is 100mbps the 100 LED is turned on. When 10mbps Ethernet is

connected it will be off. ‘

Link

When the Ethernet link layer is established the Link LED is turned on.

Ready

When the system is running and ready the Ready LED is turned on. If the system is not ready the LED will start

flashing. In TFTP mode the Ready LED is flashing and all other LED’s are off.

Front LED

The front LED is green when the system is running and the subscriptions are read

Software and help files are available at: http://www.kirktelecom.com/Installers/suk227.asp

1 2 3 4 5

Resumo do Conteúdo

Página 1 - 2. Installation

Polycom® KIRK IP Interface Card - User Guide 1. Introduction This guide helps you setting up the KIRK Wireless Server 1500 with IP Interface Card o

Página 2

3. IP Addresses The KIRK IP Interface Card is configured with the IP address: 192.168.0.1 as a standard. This address has to be changed for customiz

Página 3 - Interface Card

5. Registration of Users on the CallManager Users have to be registered on the CallManager as well as on the KIRK IP Interface Card. Please follow th

Página 4 - 10. Pre Call Services

7. Subscription of Handsets Before registering handsets on the system, the system must be set to “subscription allowed”. The subscription setting can

Página 5 - 10. Note

Cancel Call-Forward-All: To cancel Call-Forward-All, follow these steps: Procedure Step 1 Press the hook key, and dial ** then 2 on your telephone

Comentários a estes Manuais

Sem comentários

Polycom KIRK IP Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Hardware Polycom KIRK IP. Polycom KIRK IP User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Polycom KIRK IP